Visit
to View our Partner Brands
EM-Z Modular Z-Shaped Chain
The EM-Z is a particularly robust z-shaped belt conveyor.
Its stainless steel frame with a height of 95 mm is manufactured with closed stainless steel profiles.
As a standard, the belt conveyor EM-Z is equipped with a chain made of plastic modules with cross slats, lateral guide rails and a feeding hopper with a fall-back flap.
The length of the top and bottom horizontal and inclined parts can be adjusted to the individual application. However, a total length of 4 meters should not be exceeded.
From the ground, the angle of inclination of the EM-Z can be adjusted in steps of 5° between 20° and 70°.
The cross slats may be 1, 2 or 3 inches high and their distance on the conveyor between one another can be freely selected in 1-inch steps. The plastic modular chains of the EM-Z have been approved by the FDA and are easy to clean. In addition, they are particularly hard-wearing and easy to service thanks to the possibility of replacing individual links.
As a standard, the horizontal part is provided with small rollers as support to enable an easy movement of the belt conveyor. A double support can be inserted in the inclined part, as shown in the figure above. A mobile H-shaped single column support can also be used. All support systems are infinitely adjustable in height.
Technical Specifications and Accessories
Useable belt widths: 182 mm, 258 mm, 334 mm, 410 mm, 486 mm or 562 mm.
Distance between axes A1 horizontal bottom: 500 to 3.000 mm. All intermediate lengths possible.
Distance between axes A2 inclined: 500 to 3.000 mm. All intermediate lengths possible.
Distance between axes A3 horizontal top: 500 to 3.000 mm. All intermediate lengths possible.
Total length A1 + A2 + A3: no more than 4.000 mm.
Drive unit with constant belt speed:
V = approx. 5,6 / 10,4 / 15,6 / 20,8 / 31,2 or 44,6 m/min. Further belt speeds are available upon
request. Supply for 220/240 – 380/415 V, 50 Hz. Protection type IP 54. This drive unit can be
delivered ready to be connected including a protective motor switch with an emergency stop
and a power line of 2 meters length with a CEE plug. Protection type IP 65.
Drive unit with infinitely adjustable belt speed:
V = approx. 2,2-7,8 / 4,2-14,6 / 6,2-21,8 / 8,3-29,1 / 12,5-43,7 or 17,8-62,4 m/min.
Further belt speeds are available upon request. The belt is delivered with a connected digital
frequency controller, ready to be plugged in for 230 V, 50 Hz. Protection type IP 65.
Geared motor position: The geared motor can be placed pulling on the left or right side. It can
be turned in single steps by 90°.
Total belt load: Standard load 30 kg. Higher loads are available upon request.