Visit
to View our Partner Brands
GK-80 Inclined Belt Conveyor
The inclined belt conveyor GK-80 is equipped with a receiving hopper and it has cross slats on the belt. Along the belt run fixed side rails to guide the transported goods.
With these aids it can lift all sorts of bulk and solid material to the required height
Made of coated steel profiles, the frame has perforations of 9 mm diameter at 30 mm intervals. Therefore additional accessories can be added very easily.
The height of the slats on the belt and their distance to each other can be adapted to suit almost any specific application.
The standard height of the side rails is 35 mm. Higher versions are possible upon request.
The hopper exists in a small and a large standard version. both are equipped with a fall back flap to avoid any material falling back through the hopper.
Configurations no longer than 2,000 mm and no wider than 400 mm can be mounted on one H-shaped single column support that is moveable on security casters with brakes. All longer or wider conveyors should have the appropriate amount of double supports. The short support near the hopper can be equipped with small caster to make any change of location quite simple.
All supports are pivotable and infinitely adjustable in height.
Technical Specifications and Accessories
Belt widths:
200, 300, 400, 500, 600, 700, 800, 900 and 1000 mm. Intermediate widths are possible upon request.
Distance between axes / length:
750 to 18,000 mm. All intermediate lengths are possible.
Drive with constant belt speed:
v = approx. 6,1 / 11,4 / 17,1 / 22,8 / 34,2 or 48,8 m/min.
Other belt speeds are possible on request. Connection for 220/240 – 380/415 V, 50 Hz. Protection type IP 54. This drive can be supplied together with a motor protection switch incorporating an emergency off. It has a 2 metre supply cable and CEE plug and is of protection type IP 54.
Drive with infinitely adjustable belt speed:
v = approx. ,4-8,5 / 4,6-16,0 / 6,8-23,9 / 9,1-31,9 / 13,7-47,9 or 19,5-68,4 m/min.
Other belt speeds are possible on request. The drive is supplied together with a frequency regulator that is ready to be plugged to 240V 50 Hz and has a protection type of IP 65. The frequency controller incorporates a digital motor protection switch.
Geared motor position:
Pulling the belt at its side, on the left or right.
Total belt load:
Standard is of 50 kg. Higher loads are possible on request.