Visit
to View our Partner Brands
AM-F Flat Belt Conveyor
The AM-F with plastic modular chain comes in a very slim design. Thus the frame is only 14 mm wider than the chain. Also at the defecting roller the brackets add only 40 mm of width. The whole height including the chain is only 95 mm.
It can be made within 24 hours in any length between 500 and 6000 mm.
There are 4 different belt widths between 152 and 607 mm to choose from.
The modular plastic chain is very easy to clean and especially hard wearing. Any broken or worn links can be exchanged, which allows rapid maintenance.
With the wide range of GEPPERT accessories available, the AM-F can easily be adapted to almost any specific need. You will find more information on available accessories under the column “Lot of Accessories”.
For any length of 1500 mm or less and a width of up to 304 mm the AM-F can be equipped with our single columm upright.
Longer or lager versions should use the appropriate numer of two-legged aluminium supports as shown above.
Both support systems are infinitely adjustable in height and pivotable as well as self locking in their vertical position.
Technical Specifications and Accessories
Belt widths:
153, 305, 457 and 610 mm. Other widths are available upon request.
Distance between axes / length:
500 to 6,000 mm. All intermediate lengths are possible.
Drive with constant belt speed:
v = approx. 5,6 / 10,4 / 15,6 / 20,8 / 31,2 or 44,6 m/min.
Other belt speeds are possible on request. Connection for 220/240 – 380/415 V, 50 Hz. Protection type IP 54. This drive can be supplied together with a motor protection switch incorporating an emergency off. It has a 2 metre supply cable and CEE plug and is of protection type IP 54.
Drive with infinitely adjustable belt speed:
v = approx. 2,2-7,8 / 4,2-14,6 / 6,2-21,8 / 8,3-29,1 / 12,5-43,7 or 17,8-62,4 m/min.
Other belt speeds are possible on request. The drive is supplied together with a frequency regulator that is ready to be plugged to 240V 50 Hz and has a protection type of IP 65. The frequency controller incorporates a digital motor protection switch.
Geared motor position:
Pulling below the belt or at its side, on the left or right.
Total belt load:
Standard is of 50 kg. Higher loads are possible on request.